This thesis has been carried out on behalf of IV Produkt AB and intends to set an average ratio of thermal energy losses in apartment buildings that were built during the 1960-1990. This shall be derived by analyzing the total district energy consumption that has been divided into three parts: heat energy losses (the actual heating requirements), the heating of domestic hot water and heating energy consumption for the controlled ventilation.Three different residential areas that were built during the years 1962-1966 and one that was built in 1993 has been analyzed. All residential areas are located in Växjö urban and contains between four and six apartment buildings.The analyzed objects have a mechanical exhaust ventilation systems and district heating as the heating method. No own laboratory work or experiments have been done in this thesis, the calculations have been done on the basis of parameters from VEAB, interviews with property managers, and literature studies. By calculations, we have got a result that is reported in Chapter 6.

Energy is today a very common topic, not only in Sweden but in the whole Europe. In EU they have given out a directive 2002/91/EG about buildings energy use and throw this they have forced their members to show how much energy their buildings use. In Sweden has the gouvernment established a law (SFS 2006:985) about energy declaration for buildings which demands that the building owner needs to show how much their buildings energy consumption are. Important to know is that this law doesn´t applies for industrial buildings.The report will show what the new law about energy declaration for buildings and appurtenant directions will mean for Riksbyggen. Also energy calculations will be done to be able to compare Riksbyggen buildings with the new law and directions.

A large proportion of the energy consumption is in the building industry and a large part goes to heating our homes and premises. In the developing countries' development now threatens the large consumption of energy in our earth's climate. It is in the West world that we must be good role models in terms of energy efficiency. One solution to reduce energy consumption for heating of buildings may be to continue to build low energy houses and passive houses, but it is also about rebuilding the buildings that currently have high energy consumption such as the old Million program Houses. These buildings will be standing many years and their energy consumption will not diminish over time by itself and energy prices will certainly not diminish in the future.

To be able to handle tomorrows need for limited energy consumption we need to reduce our use of energy. The building sector stands for around 40 % of all energy consumption in the society. The government has put up a goal to reduce the energy consumption in our buildings with 20 % by year 2020 and 50 % by year 2050 compared with year 1995. To be able to do reach that goal we need a more energy efficient building stock.The main part of the energy used in our buildings is used for space heating. By installing ventilation systems with heat recovery on the exhaust air it is possible to use the heat-energy in the exhaust air to warm up the incoming air.

The study aims to reduce energy consumption in apartment buildings where individual metering and charging of heat is applied. The aim is to develop planning and design for individual metering and charging in apartment buildings.The study is based on literature review, interviews and case study that include analysis of existing documents. Interviews were carried out with the property developer and the involved consultants who planned the apartment building Yasuragi. To investigate the differences the condominium association has noted in heat consumption between flats, the debit values of the heat were used to discern which houses that were furthest from the average consumption. On these flats there were temperature measurements and thermal photo shoots made for discriminating behavior and possible construction techniques which could be the explanation for the heat spread.Boverket shows that the consumption of heat can be reduced by 10-20% after insertion of individual metering and charging in an apartment block.

The energy consumption in the sectors of residential and public buildings is 40 % of the total energy consumption in Sweden. The main part, 85 %, of the energy use in these sectors is for operation of the buildings. The rest is used in the building process. When energy-efficiency measures are taken the energy use during the operation time decreases and the fraction of energy consumption during the building time increases. This project is carried out in cooperation with JM AB and concerns the energy use during the building time of production of blocks of flats at the building site.The main part of the electricity that is used during the production of apartment buildings goes into the heating of portacabins and illumination of the building during the construction phase.

The starting point for this master thesis was the product of the company "Humlegården", which allows its tenants in office buildings to follow their electricity consumption in real time, through their Smartphone's. The idea that resulted from that application is to investigate if it is possible to direct the tenants in office buildings to reduce their energy consumptions, but also to be satisfied with the indoor environment. This work addresses the factors which are the main energy consumers in office buildings. It addresses legal requirements and standards which are important to follow in order to achieve good thermal comfort in buildings. Some of them are physical climate factors like thermal environment, air quality and lightning.

The study aims to reduce energy consumption in apartment buildings where individual metering and charging of heat is applied. The aim is to develop planning and design for individual metering and charging in apartment buildings.The study is based on literature review, interviews and case study that include analysis of existing documents. Interviews were carried out with the property developer and the involved consultants who planned the apartment building Yasuragi. To investigate the differences the condominium association has noted in heat consumption between flats, the debit values of the heat were used to discern which houses that were furthest from the average consumption. On these flats there were temperature measurements and thermal photo shoots made for discriminating behavior and possible construction techniques which could be the explanation for the heat spread.Boverket shows that the consumption of heat can be reduced by 10-20% after insertion of individual metering and charging in an apartment block.

Calculated and measured energy in residential buildings is going to differ. The reason to this may be due to many factors. In this study there is a study on how these factors affect the energy use in a building. To get an insight in what defines energy, there is first a description of energy supply both worldwide and used in Sweden, followed by a description of the energy balance. In this study energy will be studied in residential buildings only.

A lot of houses built during the Million Homes Programme are in need of major renovation. Today?s technology and materials are better than in the 60?s and 70?s. Both Swedish government and the European Union have set climate goals regarding energy consumption by 2020 and 2050. Achieving these goals would require better standards in buildings than the Building regulations demands, such as Umeå municipality?s construction requirements for new buildings.The report aims to investigate if a renovation of apartment buildings from the Million Homes Programme can reach Umeå municipality?s construction requirements.

The Swedish building stock accounts for nearly 40 percent of the total energyconsumption in the country. Properties built today are likely to last for 100 years orlonger. This places high demands on long-term and smart energy solutions that willkeep the future Swedish building stock energy consumption at low levels. This thesishas focused on examining how the energy performance of buildings is affected bydifferent choices of window types in different cardinal directions. The objective wasto obtain a basis for recommendations on how window properties can be optimizedfor different types of buildings and orientations.

The purpose of this project was to evaluate how energy efficiently some of JM?s residential buildings can become in standard production. What kind of measures are needed to achieve the level of energy demand that is included in BBR12 (Boverkets Byggregler)? What measures are needed for achieving a lower demand so that the buildings could be classified as passive houses? The investigation has included a single family house and two different types of apartment blocks.The simulation programs Enorm and VIP+ have been used to calculate the energy demand of the buildings. The results from the programs have been compared with the measured energy demand for the three buildings.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.

The climate change the earth today has to face is no longer a global problem when every individual has a responsibility to act. The residents in Sweden have no understanding how their energy consumption affects the environment, nor what measures can be taken to reduce the energy consumption.The use of the energy in new Buildings is considerably lower than in the older ones as conditions have improved and the requirements have been more stringent. As most of the buildings in the future have already been constructed it´s important to take every opportunity for energy efficiency and rebuilding of available buildings will become a significant act. Reconstruction of a building contributes generally to both a reduced individual and a reduced total energy use, while new constructions only keep a low individual energy use but a increase the total energy use. For this reason we present the opportunities for reconstruction, mainly to reach the standards for a passive house..